Comments
2
Participants
3
Subscribers
3
Votes
1
Views
331
Answered
I have this simple geometrical construction, but the second sector, colored orange, does not show up unless you move the point C a bit first. I cannot see anything wrong with the actual construction, and after moving C and the sector becomes visible, it works as expected.
This is the link to the construction in question:
The same question 
the problem is the point E
you can try E=intersect(e,g,1)
I ever create two intersect(e,g) points (g as line, not ray) then select the wanted point with If() comand
also you can try uncheck the "allow outlying intersections" properti of g
alternative attached.
Note: for polar notation of points (<length>;<angle>) see also manual
Comments have been locked on this page!